For instance, if your reference contains three parallel lines, the duplicated object will only snap to a similar location with three parallel lines. Once you are done, hover over the area you wish to place your duplicate and see your object rotate into position.Īn important note to working with reference objects is that BricsCAD will use every object crossing the window as a reference and try to match the destination exactly. Carefully place your selection window, ensuring that your objects to be selected are fully inside the window, and any object crossing the window will be used as a reference. The important distinction here is that we are also selecting the references for positioning our duplicated object. Similar to default copy, Copy Guided starts off with selecting the objects you wish to duplicate. This tool works by detecting both the objects to be duplicated, and the geometric references for positioning, all in a single selection window. Copy Guided is an intelligent tool for not only copying a set of entities but also positioning them and fitting them into place. ![]() Thanks to BricsCAD’s “Copy Guided” tool this process can be much simpler. That’s at least 5 steps, all for one duplication! Sometimes, you’re not even done there, and you have to adjust the geometry around it by trimming or extending lines to accommodate the copied object. How many steps does it take you to Copy a simple object in CAD? Whether you’re copying a set of miscellaneous entities or a block, the default “Copy” command forces you to copy the object, then manipulate it to the correct orientation by flipping/rotating, and finally placing it in its final location. ![]() Autodesk Vehicle Tracking Online Courses.BIM Services for Architecture and Engineering.Construction Project Setup in Bluebeam Revu.Bluebeam Tool Chest Customization Services.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |